Soft-starters are static starting devices designed for the acceleration, deceleration and protection of the three phase electric induction motor through the control of the voltage applied to the motor. 40-50 HP - 130 Amps. 208-230 Volts - 3 Phase.AquaStart is a combination soft starter that allows easy installation with factory pre-set pump parameters. It is designed to work directly with centrifugal and submersible pumps with ease of installation. AquaStart utilizes Thermal Image Motor Protection (TIMP) to get the highest level of motor performance while fully protecting the motor for longer life. AquaStart offers enhanced motor and system protection for residential, commercial, and industrial pumping applications. Standard NEMA 4 enclosure Rugged, outdoor rated panel rated to 55°C without derating the starter.
Set up the starter in just minutes Preset for surface centrifugal motors with simple parameter change to accommodate submersible start up speeds. Use trimpots and DIP switches for parameter setting on standard units, or optional keypad for advanced settings. Two optional keypad controls available Use the removable controller keypad for advanced settings and troubleshooting on the control module, or use the through door keypad for programming without opening the panel. Standard, built-in AC1 Run Rated Bypass Automatically bypasses the soft start controller when motor is up to full amps.
Soft Starter is only engaged during start and stop of motor. The works to reduce heat inside the panel. Optional AC3 Bypass Contractor and DOL selector switch Allows user to bypass soft starter module for DOL start and stop. Full Diagnostics In addition to typical electrical protection and diagnostics, the AquaStart has a full range of motor protection features such as locked rotor, current imbalance / phase loss, and over / under current.
These features require no additional input devices. Remote on/off Permits external control by timers (irrigation), float or pressure switches (tank draining) or manual control. Featuring a WEG Model SSW070130T5SZ Soft-starter.
The SSW07, with DSP control (Digital Signal Processor), was designed to provide great performance on motor starts and stops with an excellent cost-benefit relationship. Because it is easy to set up, it simplifies start-up activities and daily operation.The SSW07 is compact, optimizing space in electric panels and incorporates all electric motor protection classification. This item was sourced directly from Xylem and is new, never used. The item "XYLEM CENTRIPRO AQUASTART AST20500 40-50 HP 130 AMPS WITH WEG SSW07 SOFT STARTER" is in sale since Tuesday, February 19, 2019. This item is in the category "Business & Industrial\Industrial Automation & Motion Controls\Drives & Starters\Starters\Reduced Voltage/Soft Starters". The seller is "jdimachinery" and is located in Dallas, Texas. This item can be shipped to United States, United Kingdom, China, Germany, Japan, France, Australia, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Greece, Portugal, Cyprus, Slovenia, Sweden, South Korea, Indonesia, South africa, Belgium, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Austria, Bahamas, Israel, New Zealand, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Bahrain, Croatia, Malaysia, Chile, Colombia, Panama, Jamaica, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman islands, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Pakistan, Paraguay, Reunion, Uruguay.